Where Is the Whirlpool Refrigerator Water Filter Located?

The Whirlpool refrigerator water filter is located in the back, right-hand corner of the refrigerator.

Checkout this video:

1. The Whirlpool refrigerator water filter is located in the back, right-hand side of the refrigerator.

1. The Whirlpool refrigerator water filter is located in the back, right-hand side of the refrigerator.
2. To replace the filter, open the fridge door and locate the filter housing inside the upper right-hand corner.
3. Turn the old filter counterclockwise to remove it, and then discard it according to your municipality’s waste disposal regulations.
4. To install the new filter, insert it into the housing and turn it clockwise until it stops.
5. flushed according to the manufacturer’s instructions before use.

2. To replace the water filter, first locate the filter cap in the ceiling of the refrigerator compartment.

To replace the water filter, first locate the filter cap in the ceiling of the refrigerator compartment. The filter cap is located on the left side of the ceiling. The filter cover has a simple quarter turn design. Turn the cover counterclockwise until it stops, then pull down on the cover to remove it. After removing the filter cover, you will see the water filter cartridge (it will be in a white plastic housing).

3. Remove the filter cap by turning it to the left.

The Whirlpool refrigerator water filter is located in the back upper-right corner of the refrigerator compartment. To access and replace the filter, follow these steps:

1. Locate the filter cap in the upper-right corner of the refrigerator compartment.

  How To Change Your Well Water Filter

2. Remove the filter cap by turning it to the left.

3. Pull the old filter straight out and discard it according to manufacturer’s instructions.

4. Push the new filter into place until it clicks, then replace the filter cap by turning it to the right.

4. Pull the old filter straight down and out.

The Whirlpool refrigerator water filter is located in the refrigeration unit, behind the kick plate at the bottom of the fridge. To replace the filter, follow these steps:

1. Open the refrigerator door and locate the water filter housing.
2. Push on the release tab to open the housing cover.
3. Pull the old filter straight down and out.
4. Insert a new filter into the housing, pushing it up until it clicks into place.
5. Close the housing cover and enjoy your fresh, filtered water!

5. Push the new filter up into the filter housing until it clicks into place.

Screw the new filter onto the housing clockwise until it is tight, then push the filter release button to make sure the filter is locked in place.

6. Replace the filter cap by turning it to the right.

To replace your Whirlpool refrigerator water filter, first locate the filter. The filter is usually located in the grille at the bottom of the fridge or in the back upper-right corner. To replace the filter, first remove the cap by turning it to the left. Then, remove the filter by turning it to the left and pulling it out. To insert the new filter, first wet the O-rings on the new filter with clean water. Then, insert the new filter into the housing and turn it to the right until it clicks into place. Finally, replace the cap by turning it to the right.

  How To Install Rpwfe Water Filter?

7. Run water through the new filter for 5 minutes to prime it.

To prime the filter, run water through it for 5 minutes. The water will not be filtered during this time, so it is best to do this step just before you go to bed so that the majority of the water has time to filter overnight. Once the water has been running through the filter for 5 minutes, you can restart your refrigerator and begin using it as normal.

8. Discard the first few batches of water that come out of the filter.

8. Discard the first few batches of water that come out of the filter.
This will help to remove any impurities that may be present in the filter.

9. The water filter should be replaced every 6 months.

The water filter on your Whirlpool refrigerator is located in the bottom right corner of the fridge, behind the kick plate. To replace it, simply unscrew the old filter and screw in the new one. Make sure to flush the water filter for at least 3 minutes before using it.

10. If the water from the refrigerator tastes bad, the water filter may need to be replaced sooner.

The water filter is located in the upper right-hand corner of the refrigerator compartment. The water filter should be replaced every six months to ensure that the water from the refrigerator tastes fresh and clean.

Scroll to Top